How to disable the Aveox Overtemp Cutout.

First of all, this procedure will void the warrantee of your Aveox controller. It's also a little tricky. I was sweating when I did mine and was real glad when I was done! Here's the deal:

First, find the chip closest to the hall sensor plug and look at the row of pins closest to the hall sensor plug. Then count from the left 3 pins over. Next, pry the third pin off of the board and bend it over to the fourth pin and solder it to it. That's it.

Once again, doing this procedure is at your own risk and will void the warranty. Remember, the overtemp cut out is for the controllers protection. If you're having cutout problems at 4 laps like I was I wouldn't suggest running the boat more then what it takes to finish the race. Do your 5 laps and bring it in. Also, This is not a substitute for water cooling. All efforts should be used to run the controller without this modification. If you are uneasy or unsure about this procedure DON'T DO IT. Aveox has said they would reprogram the chip to set the overtemp cutout from 90 to 120 C. This will also void the warrantee, but may be a better solution.